16
Q
Drum Assembly
1.
Remove the top cover as in (A)
2.
Remove the console as in (B)
3.
Remove the front panel as in (G).
4.
Remove the right hand panel to make drum removal easier.
5.
Remove the rear bearing cover - 2 screws.
6.
Remove one Earth strip fixing screw, slacken the other, and turn the Earth strip to allow access
to the drive pin.
7.
Remove the drive pin and shaft collar.
Note: When reassembling, a new drive pin must be fitted.
8.
Remove the rear bearing.
9.
Pull the drum clear of the rear panel.
R
Motor
1.
Remove the right hand side panel as in (F).
2.
Remove the heater cover - 8 screws.
3.
Remove the 2 fans from the motor hub - 3 hex head screws.
Note: The inner and outer fans are DIFFERENT.
Ensure fans are reassembled in the correct order.
4.
Note the wiring connections and disconnect the motor at the in-line connector and the capacitor.
5.
Disengage the drive belt from the motor shaft as in (O2).
6.
Remove the 3 hex head screws securing the motor to the motor cradle.
7.
Remove the 2 screws securing the cradle to the base panel if necessary.
Note: When refitting the heater cover ensure that the heater wiring is not trapped between
the heater cover and rear panel.
Raised
Recessed Hub
Fan Orientation
Hub
Inner
Outer
Inner
Outer
