135 mm
2
8
1
m
m
MOUNTING INSTRUCTIONS / TEMPLATE
THE DRYER MUST BE PROPERLY EARTHED.
FOR FIXED INSTALLATION, CONNECT VIA CIRCUIT BREAKER.
MOUNTING INSTRUCTIONS:
1.
Attach this mounting instruction sheet / template to the wall with tape.
Recommended installation height is 115 cm from the floor to holes C
and D (95 cm for children or the disabled).
Do not mount directly above
sink or the like.
2.
Drill 4 holes (A, B, C, D - 8 mm diameter, 35 mm deep).
3.
Remove the mounting instruction sheet from the wall. Hammer the dowels
supplied into the four holes.
4.
Remove the housing from the base plate. Pull the power cord at least 7 cm
through the hole in the base plate. Secure the base plate to the wall.
5.
Connect wires as follows:
A.
Connect the live wire (red or brown) to the terminal block where
marked ”L”.
B.
Connect the neutral wire (blue or black) to the terminal block where
marked ”N”.
C.
Connect the green and yellow earth wire to the screw marked ” ”.
IMPORTANT: Do not lift the dryer by the electrical parts during installation.
6.
Remount the housing onto the base plate and secure the housing properly.
Test run the dryer
.
12.5 mm
18.5 mm
IMPORTANT!
This product is covered by the WEEE
regulations on the recycling and recovery of waste
electrical and electronic equipment.
• This products is not to be treated as household refuse.
• This product must be recycled if possible.
• Contact local authorities for advice.
• The product may also be returned to the manufacturer/
distributor free of charge. The manufacturer/distributor
will ensure proper recycling/disposal.
RECOMMENDED INSTALLATION HEIGHT:
115 CM FROM THE FLOOR FOR ADULTS / 95 CM FOR CHILDREN AND THE DISABLED.
Ø 22 mm
HOLE FOR
CABLE
ENTRY
