9
ENGINE DRIVEN PIVOTS
WIRING INSTRUCTIONS FOR BASIC OPERATION
Typically all functions switches are off unless advanced features are needed. See function
switch setting on page 3 for details.
Attention:
This install requires a 12vdc relay.
Run a wire from the B terminal on the engines Murphy switch to the +12vdc input on
the transmitter. Run a wire from the ground on the Murphy or from the NEG of the engines
battery to the NEG input on the transmitter. Now install a 12vdc Interface Relay to control the
SENSOR inputs on the transmitter. To control the 12vdc Interface Relay run a wire from the
engines Murphy switch terminal C on a 117 or from the terminal NC on a 518 to one side of the
relays coil terminals. Run another wire from the ground on the Murphy or from the NEG of the
Hot Shot Transmitter to the other coil terminal on the 12vdc Interface Relay. Now run a wire
from the 12vdc Interface Relay
’
s NO terminal to the ON
-
OFF INPUT on the transmitter. Run
another wire from the 12vdc Interface Relay
’
s COM terminal to the COM input on the transmit-
ter. Connect a wire from the Lighting Ground terminal of the Hot Shot to the ground lug of the
panel.
See diagrams below
.
