11
ZIMMATIC PIVOT 11 WIRE SYSTEM
WIRING INSTRUCTIONS FOR BASIC OPERATION
Typically all functions switches are off unless advanced features are needed. See function
switch setting on page 3 for details.
Attention:
This install requires a 24vac relay.
To supply the 120v needed for the Hot Shot Transmitter to operate run a wire from the
pivot panels 120v X1 terminal to the 120vac Hot terminal on the transmitter. Run another wire
from the 120v X2 terminal to the 120vac Neutral terminal on the transmitter.
INSTALL
a
24vac relay
“
Interface Relay
”
to control the Sensor input on the transmitter. Control the Inter-
face Relay by running a wire from one side of the relay coil to terminal #64 and connect the
other side of the relay coil to terminal #65. Wire the N.O. side of the Interface Relay to the ON
-
OFF INPUT terminal on the transmitter. Wire the COM terminal of the Interface Relay to the
COM terminal on the transmitter. Connect a wire from the Lighting Ground terminal of the Hot
Shot to an NEC approved ground rod.
See diagram below
.
