1
D. Installation of the Icemaker
CAUTION
1. Power supply and ground wire to the icemaker are supplied from the
condensing unit. For details, see section "II.F. Electrical Connection."
2. Before operating the icemaker, the bin control must be installed correctly.
Failure to properly install the bin control could result in ice backup and unit
damage.
1. Setup
1) If mounting the unit on top of a dispenser unit, follow the dispenser unit's setup
procedure. If mounting the unit on top of a storage bin, unpack the storage bin, and
attach the 4 adjustable legs provided (bin accessory) to the bottom of the storage bin.
2) Position the dispenser unit/storage bin in the selected permanent location.
3) Place the icemaker on top of the dispenser unit/storage bin and secure.
4) Level the icemaker and dispenser unit/storage bin in both the left-to-right and front-to-
rear directions.
2. Bin Control Installation
Follow the instructions below to remove the bin control from the shipping area and install
the bin control.
1) Remove the front frame: Remove the two thumbscrews and lift off.
Front Frame
1
Bin Control
