P400T V2 Portable Beer Disperser
240V / 50Hz
www.lancerbeverage.com
Page 7 of 17
Hoshizaki Lancer reserve the right to change specifications without notice.
Part No: 68000019
Images are for illustration purposes only as product may vary.
041 – 14 November 2014
6.3 Selecting a Location
Warning
Chillers are intended for indoor operation only; do not
operate outside unless suitably protected by a
weatherproof enclosure.
This appliance is not suitable for installation in an area
where a water jet could be used.
This appliance is not intended to be installed in a
kitchen.
Caution
The Chiller is not suitable for use in subfreezing temperatures.
To prevent damage turn off and drain unit when air temperature
is below zero.
The Chiller should be located in a well-ventilated, firm, level location.
The appliance is only to be installed in location where its use and maintenance is restricted to
trained personnel.
Ensure sufficient clearance around Chiller to allow good fresh air circulation through the condenser
– allow at least 200mm at rear and sides, with the front unobstructed.
Installation should only be performed by a qualified and competent technician.
6.4
Connecting Taps and fitting Drip Tray
Open lid and remove drip tray and 2 beer taps.
Remove plugs from taps and place inside unit for
storage.
Fit taps into the fat-lock fittings in front of unit.
Fit drip tray into the slots in the front panel.
Taps and the drip tray can be stored inside the unit when transporting and storing.
6.5 Connecting Beer Lines
Before connecting sanitise all beer lines with beer line cleaner.
Connect beer lines from the keg to the fat-lock fittings on the right hand side of the chiller.
6.6 Electrical
Connection
This unit has a 240 Volt 10 amp socket on the left hand side of the machine and requires a
approved suitable extension cord to connect it to the 240 Volt 50 Hz electrical supply mains.
It is recommended that this appliance is connected to a separate 240VAC 50 Hz supply, protected
by an appropriate circuit breaker and Residual Current Device (RCD).
The service of a licensed electrician may be required to ensure the installation is in accordance
with the local codes and regulations.
Warning
If the supply extension cord is damaged, it must be replaced.
Have it checked by a qualified persons in order to avoid a
hazard.
Warning
To prevent possible electrical shock or extensive damage to the
unit, the appliance must be connected with an extension cord
to an appropriate electrical outlet socket installed in
accordance with local codes and regulations i.e. AS/NZS 3000.
