12
ENGLISH
NOTICE
Remove shipping carton, tape(s) and packing. If packing material is left in the icemaker, it will not work properly.
Note: This icemaker needs a storage bin. Hoshizaki recommends the following ice storage bins:
B301SA
------------------------- IM-220AA
B501SA (Top Kit 8D) -------- IM-220AA
B801SA (Top Kit 4DM) ------ IM-220AA x 2
1) After removing the packaging, make sure that the icemaker and the storage bin are in good condition. If in doubt, please do
not use the icemaker but apply to professionally quali
fi
ed personnel. See the instruction sheet attached to the storage bin for
its unpacking and installation guidelines.
2) Remove the icemaker panels to gain access to the accessory kit and to assist easier installation.
3) Remove the package of accessories. Check the contents according to “2. ACCESSORIES”.
4) Remove the shipping tape holding the bin control switch.
5) Remove the protective plastic
fi
lm from the exterior. If the icemaker is exposed to the sun or to heat, remove the
fi
lm after the
icemaker cools.
4. LOCATION
WARNING
This icemaker is not intended for outdoor use.
The icemaker should not be located next to ovens, grills or other high heat producing equipment.
This appliance is not suitable for installation in an area where a water jet could be used.
In some high humidity environments, condensation may form inside the machine and drip onto the
fl
oor. Do not install where
the
fl
oor can be affected by water.
CAUTION
The location should provide a
fi
rm and level foundation for the icemaker.
NOTICE
Do not place anything on top of the icemaker or in front of the louver.
IMPORTANT
Normal operating ambient temperature should be within 1°C to 40°C. Normal operating water temperature should be within
5°C to 35°C. Operation of the icemaker, for extended periods, outside of these normal temperature ranges may affect
production capacity.
a) Front Cover: Remove the screw(s).
Lift up and pull toward
you.
b) Top Panel: Lift up the front, and
slide backward to
unhook the rear.
c) Rear Panel: Remove the screw(s),
and take off.
d) Side Panel: Remove the screw(s),
and take off.
Bin Control
Switch
