48
10) Replace the Cutter, Cylinder Packing, Spouts, Packing and panels in their correct position.
11) Open the water supply tap.
12) Plug in the ice dispenser.
13) Check for water leaks.
WARNING
After assembling the Extruding Head, be sure to check that the Auger does
not contact with the inner surface of the Evaporator and there is not any ab-
normal noise from the Bearing.
[c] AUGER
1) Unplug the ice dispenser.
2) Close the water supply tap.
3) Remove the Extruding Head. (See “[b] EXTRUDING HEAD”.).
4) Open the Drain Valve by rotating the knob , and after draining water, close the Drain
Valve.
5) Lift and remove the Auger.
6) Install the new Auger.
7) Assemble the removed parts in the reverse order of which they were removed.
8) Open the water supply tap.
9) Plug in the ice dispenser.
10) Check for water leaks.
[d] MECHANICAL SEAL
1) Unplug the ice dispenser.
2) Close the water supply tap.
3) Remove the Bearing - Lower. (See “[a] GEAR MOTOR AND BEARING - LOWER”.)
Note: The Bellows portion of the Mechanical Seal will be removed together with the
Auger.
Summary of Contents for DCM-230FE
