9
2) Turn the regulator adjust dial counterclockwise to “0”.
3) Move the beer tap lever toward you to dispense beer remaining
in the circuit. Loosen the union nut of the beer tap by turning it
clockwise, and remove the beer tap.
4) Loosen the cap nut of the beer tap, and remove the lever.
5) Remove the valve shaft from the beer tap.
Valve shaft
Cap nut
Lever
6) Clean the beer tap and valve shaft by using a neutral dishwashing
detergent and the accessory cleaning brush.
7) Use the accessory brush (S) to clean the two small holes in the
beer tap.
8) Rinse the beer tap thoroughly with clean water.
Valve shaft
Hole
Brush (S)
Small hole
Small hole
Beer tap cross section
6. KEG COUPLER (WEEKLY)
Clean the keg coupler in accordance with the beer company’s
instruction manual.
7. EXTERIOR (WEEKLY)
The stainless steel exterior also needs cleaning to prevent possible
corrosion. Wipe with a soft cloth. Use a soft damp cloth containing a
neutral dishwashing detergent to wipe off dirt buildup, and remove any
remaining detergent. Clean the exterior whenever necessary.
8. AIR FILTER (BIWEEKLY)
1) Remove the drain pan.
2) Pull the air filter slightly toward
you. Push it down, and pull it out.
3) Wash the air filter with cold water
or warm water containing a neutral
dishwashing detergent. Be careful
not to break the net. After using
a detergent, rinse the air filter
thoroughly. Dry it in the shade.
Drain pan
Air filter
4) Fit the air filter into the filter guide at the bottom, and slide it to the
back.
5) Refit the drain pan.
IMPORTANT
1. When the air filter is clogged with dirt and dust, the unit
cannot operate properly.
2. Do not operate the unit with the air filter removed. The
condenser will clog easily.
3. To prevent deformation, do not wash the air filter with hot
water above 40°C.
4. Do not hit or drop the drain pan and air filter while cleaning
them.
IV. INSPECTION
1. GAS HOSE AND BEER HOSE (MONTHLY)
Check the gas and beer hoses for damage, deformation, and water
leak marks (stains). If any problem is found, contact an authorized
Hoshizaki service company.
2. ATTACHMENT PLUG AND POWER CORD (ANNUALLY/
BIANNUALLY)
CAUTION
1. Check periodically that the attachment plug blades and
their vicinity are free of dust and that the attachment plug is
securely plugged into the receptacle. Dusty blades or loose
connection may cause electric shock or fire.
Keg coupler handle
Rotary type
Vertical type
9) Assemble the beer tap properly by positioning the hole in the valve
shaft (larger hole facing up).
