Hoshizaki DBF-25SAC, Instruction Manual

Page: 33 / 36

30
ENGLISH
3. DRAIN PAN (DAILY)
Wipe the drain pan surfaces by using a cloth containing warm water
(30 - 40°C) with invert soap. After 3 minutes, wipe off any remaining
soap with a clean cloth containing cold or warm water. Clean the
drain pan whenever necessary.
1) Remove the grille, and lift the drain pan to release its mounting
holes from the mounting screws. Be careful not to spill water and
beer collected in the drain pan.
2) Dump water and beer, and wash the grille and drain pan with tap
water.
3) Lift the drain pan to hook the mounting holes on the mounting
screws, and set the grille on the drain pan.
4) Check that the overflow hose goes through the hole in the grille
and can drain water into the drain pan.
4. CLEANING BEER CIRCUIT WITH SPONGE (WEEKLY)
IMPORTANT
Store the used cleaning sponge for later use.
Use the cleaning tank specified by the beer company. Follow the operating instructions provided on the cleaning tank.
Use one of the cleaning sponges provided. To prevent clogging, do not use more than one sponge or any sponge other than
those provided.
1) Close the beer circuit before flushing.
Rotary type: Turn the keg coupler handle counterclockwise.
Vertical type: Unlock and lift the keg coupler handle all the way up.
2) Turn the regulator adjust dial counterclockwise to “0”.
3) Shut off the CO2 gas cylinder by turning the main valve clockwise.
4) Move the beer tap lever toward you to dispense beer remaining in the circuit.
5) When no more beer comes out, move the lever back to its original position.
6) Loosen the union nut of the beer tap by turning it clockwise, and remove the
beer tap.
7) Loosen the cap nut of the beer tap, and disassemble the beer tap. Fit the valve
shaft in the opposite direction as shown, and tighten the cap nut. (This is to
prevent the cleaning sponge from clogging the beer tap.)
8) Attach the beer tap on the unit by tightening the union nut.
9) Prepare a plastic bucket under the beer tap to receive drain water.
10) Wash the cleaning tank thoroughly, and fill it with tap water.
11) Remove the quick beer hose joint from the keg coupler, put only one cleaning
sponge into the joint, and refit it on the keg coupler.
12) Attach the keg coupler on the cleaning tank.
13) Open the CO2 gas cylinder by turning the main valve two or three times
counterclockwise.
14) Turn the regulator adjust dial, and adjust the gas pressure to 0.15 MPa or the allowable range specified on the cleaning
tank.
Mounting
Screw
Through Hole for
Overflow Hose
Grille
Drain Pan
Overflow Hose
Beer Tap Lever
Cap Nut
Valve Shaft
Valve Shaft
1
2