Hoshizaki DBF-25SAC, Instruction Manual

Page: 27 / 36

24
ENGLISH
[d] EXTERNAL BEER LINE
NOTICE
Cut the beer hose with a specialized tool such as hose cutter. Do not use scissors, or the beer hose may be crushed to cause
beer leaks.
Do not disconnect and reinsert the beer hose. Cut it about 20 mm before reuse.
Cut the hose end vertically, insert it securely into the quick joints, and check for beer leaks.
1) Attach the beer hose joint specified by the beer company on the beer inlet.
2) Determine the positions of the beer hose joint and beer keg to make the beer hose length within 2.1 m.
3) Cut the beer hose to have a vertical cutting plane.
4) Insert the beer hose into the quick joints on the keg coupler and beer inlet. Pull the hose hard to check for tight connections.
7. TRIAL RUN
[a] HOW TO MAKE COOLING WATER
IMPORTANT
Carefully read this before filling the water tank.
Electric conductivity (E.C.) of cooling water for water tank
Do not use tap water.
Fill the water tank with water having 100-300 μS/cm of E.C.
Measure the electric conductivity with conductivity meter.
* E.C. : Physical property to show the ability of conducting electricity.
Unit: μS(microsiemens)/cm
Below 100 μS/cm:
Compressor may not work resulting in poor cooling performance.
Above 300 μS/cm:
Excessive ice may build up on evaporator and freeze beer inside beer coil preventing beer from being dispensed properly.
How to make cooling water with 100-300 μS/cm of E.C.
The capacity of the water tank of this unit is approx. 16 L (DBF-40SAC/WAC) / 10 L (DBF-25SAC).
Make the cooling water by dissolving 3 g (DBF-40SAC/WAC) / 2 g (DBF-25SAC) of pure baking soda in approx. 16 L / 10 L of
distilled water.
Step 1
Measure 3 g / 2 g of pure baking soda with nozzle cap (accessory).
Step 2
Fill a bucket with approx. 16 L / 10 L of distilled water and stir well after adding the 3 g / 2 g of
baking soda measured in step 1.
Use a conductivity meter if measuring E.C.
Rinse the nozzle cap after use.
[b] COOLING WATER SUPPLY
WARNING
To prevent injury, do not touch the edges of the front panel or wire condenser when the top panel is removed.
NOTICE
When filling the water tank, be careful not to splash water onto the electrical parts.
Do not fill the water tank above the water level line, or the drain pan will overflow and spill water.
Distilled Water
(approx. 16 L / 10 L)
Bucket
Nozzle Cap
1/2 (3 g) /
1/3 (2 g)
Nozzle Cap
Cap for Foam
Nozzle (1 g)