horsch 34362342, Operating Instructions Manual

Page: 41 / 67

NOTE
¾
Set all discs to the same height.
Support wheels
The support wheels prevent building up and
stabilise the machine on uneven ground.
NOTE
The support wheels should not carry the weight
of the machine and must not be used for depth
guidance.
¾
Set both support wheels to the same height.
WARNING
Risk of injury when adjusting the support wheels.
¾
Always pull out the pin for removal. Never
reach into the holes or push the pin through!
¾
Secure the support wheel against dropping
(place a board underneath, or similar).
The support wheels must first be turned up
when the working depth is enlarged with the
depth setting.
Terrano 4 FX / 6 FX
1
2
1 Adjustment lever
2 Row of holes with pins
1. Lower the machine until the coulter is posi-
tioned just above the ground.
2. Insert the adjustment lever (1) and secure it
with the cotter pin.
3. Relieve the pin (2) with the adjustment lever
and pull it out.
4. Position the support wheel with the adjust-
ment lever to the next hole.
5. Insert the pin (2) and secure it.
Repeat operation (2 - 5) until the support wheels
are just above the ground when in use.
Terrano 5 FX
Support wheel Terrano 5 FX, pin in rear row of holes
1. Lower the machine to the working depth.
2. Lift the support wheel with a suitable imple-
ment until one of the pins can be removed.
The support wheel can then (limited by the
guide between the perforated plates) be
adjusted.
3. Remove a pin.
4. Adjust the support wheel; insert the pin in the
front or rear row and secure it.
5. Position the other pin, if necessary, in the
same row of holes.
¾
Alternatively, drive the machine far enough
into the soil until the support wheels come to
rest and the pins can be removed.
¾
Remove the pins.
¾
Retract the machine slightly deeper than the
intended working depth.
¾
Insert the pins and secure them with cotter pins.
The support wheel has vertical clearance if only
one pin is inserted.
37