20
© 2 0 0 5 D i r e c t e d E l e c t r o n i c s — a l l r i g h t s r e s e r v e d
4. P
Prrooggrraam
m.. Press and hold the
button on the transmitter.
The parking lights will flash Off and then back On to
acknowledge transmitter programming.
To add additional transmitters (within 10-seconds of the first
transmitter) Press and hold the
button on the additional
transmitter.
c
co
on
nttrro
oll m
mo
od
du
ulle
e p
prro
og
grra
am
mm
miin
ng
g
Dependent on the vehicle, use the following data with the
instructions to program your system. These wire loops are found
at the side of the control module.
D
Diieesseell M
Mood
dee ((B
BL
LU
UE
E)) - Cut this loop if you have a diesel vehicle.
When cut the remote start will start the engine about 30 seconds
after pressing the
button twice.
Uncut – Gas Mode
Cut – Diesel Mode
IIggn
niittiioon
n C
Coon
nttrroolllleed
d D
Doooorr L
Loocckkss ((R
RE
ED
D)) - Default is door locks
activate on ignition On or ignition Off. Cut this loop to disable
ignition controlled door locks.
Uncut – Door locks will activate 3-seconds after the igni-
tion is turned On and will immediately activate when the igni-
note:
If the parking lights did not flash the trans-
mitter learn was not successful. Return and repeat
from step 1 this procedure.
