CH. 3
14 MAY 2002
PAGE 13
MAN0484-01
CHAPTER 3: CONFIGURATION
3.1
General
Chapter Three covers the configuration of the JCM200. The purpose of the configuration is to allow
communication between an OCS/RCS and an Engine Control Module.
Note:
To perform this configuration, it is necessary to consult the engine manufacturer’s user
documentation to determine parameter numbers and the corresponding number of words
for each parameter.
3.2
Configuration
a. First, invoke Cscape. From the Cscape Main Menu, select
Controller | I/O Configure…
.
Figure 3.1 – Select the Module Slot
Ensure that the desired controller is selected. The OCS300-CsCAN is shown as the selected controller
(Fig. 3.1) in this example. If satisfied with the controller selection, press a
Base #
tab, and go to Step 3.
If a different controller is desired (as it is in this configuration example), continue Step 2.
Note:
The
Auto Config System
button can be pressed
prior
to selecting the desired controller
and
I/O.
By pressing the button, the settings are deleted from any controller
and
I/O that is physically connected to
the PC. A dialog box appears and indicates that settings will be deleted from currently configured
models. If OK, press
Yes
. Then press
OK
.
Ensure the correct
controller is
selected. To change
controllers, press
CPU Slots
and
select the desired
module.
You can add an I/O
module to any slot,
but Slot 1 must not
be empty.
