PAGE 9 12-5-97 CHAPTER 2: INSTALLATION
3.
Install the supplied plastic 1/2" standoff (A') in hole (A).
Figure 2-2. Drive Mounting Holes and Connectors (left), Mounting Hardware (center, not to
scale), and Option Card Location (right).
Drive shown above is 1/2HP, viewed from the front.
4.
Install the HE300 option board. Use the plastic guides (B) to properly align the bottom of
the option board. Snap the option board into the standoff (A') and option connector (C).
5. Install the supplied M3 x 5 screw (D') with washer in hole D to secure the option board.
6.
Verify that jumper JP4 is in place.
7.
After inserting the Phoenix-type connector into the proper receptacle (P1), completing
field wiring to the terminal strip(s) and installing the manual override connection wires and
capacitor, replace the front cover.
8.
Power up the drive as needed.
