12
13
Step 7
6. Attach the clevis from the rudder pushrod into the
outermost hole of the control horn on the rudder, and
slide the clear rubber sleeve down over the clevis.
7. Attach the clevis from the elevator pushrod into the
outermost hole of the control horn on the bottom of
the elevator. Slide the clear rubber sleeve down over
the clevis. Again, refer to the instructional video for a
more detailed explanation.
push up
pull down
Attaching the Tail (continued)
Step 7
1. Locate the rudder and horizontal stabilizer assemblies
and carefully remove them from the box.
2. Install the rudder assembly into the horizontal
stabilizer, as shown.
3. Install the complete tail assembly into the fuselage,
as shown.
4. Secure this assembly to the fuselage, from the
bottom, with the included screws. The two screws
needed for this step are in the small bag labeled “C”
and are the two longest included.
5. Clip the tail wheel wire into the plastic wheel housing
by pulling down slightly on the tail wheel, at
the same time you are pushing up on the plastic
molding until the two parts “snap” together. Make
sure to support the tail when doing this so that no
damage is done to the aft fuselage area.
Attaching the Tail
