EN
7
To Enable SAFE Select
To Enable SAFE Select
To Disable SAFE Select
To Disable SAFE Select
Using The Bind Button...
Using The Bind Plug...
SAFE SELECT ENABLED:
The control surfaces cycle back and forth
twice
with a slight pause at neutral position every time the receiver is powered on.
SAFE SELECT DISABLED:
The control surfaces cycle back and forth
once
every time the receiver is powered on.
SAFE SELECT DISABLED:
The control surfaces cycle back and forth
once
every time the receiver is powered on.
SAFE SELECT ENABLED:
The control surfaces cycle back and forth
twice
with a
slight pause at neutral position every time the receiver is powered on.
Press and hold Bind Button
Press and hold Bind Button
Release Bind Button
Orange Flashing LED
Connect Power
Lower Throttle
Bind TX to RX
Bind TX to RX
Lower Throttle
Connect Power
Release Bind Button
Orange Flashing LED
Install Bind Plug
Remove Bind Plug
Connect Power
Bind TX to RX
Lower Throttle
Install Bind Plug
Remove Bind Plug
Lower Throttle
Connect Power
Bind TX to RX
Orange Flashing LED
Orange Flashing LED
BIND
BIND
BIND
BIND
Transmitter and Receiver Binding / Switching ON and OFF SAFE Select
The BNF Basic version of this airplane includes SAFE Select technology, enabling you to choose the level of flight protection. SAFE mode includes angle limits and
automatic self leveling. AS3X mode provides the pilot with a direct response to the control sticks. SAFE Select is enabled or disabled during the bind process. With SAFE
Select disabled the aircraft is always in AS3X mode. With SAFE Select enabled the aircraft will be in SAFE Select mode all the time, or you can assign a switch to toggle
between SAFE Select and AS3X modes.
Thanks to SAFE Select technology, this aircraft can be configured for full-time SAFE mode, full-time AS3X mode, or mode selection can be assigned to a switch.
IMPORTANT:
Before binding, read the transmitter setup section in this manual and complete the transmitter setup table to ensure your transmitter is properly
programmed for this aircraft.
IMPORTANT:
Move the transmitter flight controls (rudder, elevators, and ailerons) and the throttle trim to neutral. Move the throttle to low before and during binding. This
process defines the failsafe settings.
You can use either the
bind button
on the receiver case
OR
a conventional
bind plug
to complete the binding and SAFE Select process.
• The included receiver has been specifically programmed for operation of this
aircraft. Refer to the receiver manual for correct setup if the receiver is replaced.
• Keep away from large metal objects while binding.
• Do not point the transmitter’s antenna directly at the receiver while binding.
• The orange LED on the receiver will flash rapidly when the receiver enters bind
mode.
• Once bound, the receiver will retain its bind settings for that transmitter until
you re-bind.
• If the receiver loses transmitter communication, the failsafe will activate.
Failsafe moves the throttle channel to low throttle. Pitch and roll channels move
to actively stabilize the aircraft in a descending turn.
• If problems occur, refer to the troubleshooting guide or if needed, contact the
appropriate Horizon Product Support office.
General Binding Tips and Failsafe
