Tail Installation
1. Slide the horizontal stabilizer (
A
) into the slot of the fuselage.
2. Center the horizontal stabilizer and then secure into place with the 4 included
pieces of tape (
B
).
3. Connect the LED connector of the horizontal tail into the LED connector
installed in the fuselage. The orange signal wire is furthest forward.
4. Connect the clevis to the elevator control horn (
C
) as shown.
1.
2.
3.
4.
5.
6.
Connecting a Clevis
1. Pull the tube from the clevis to the linkage.
2. Carefully spread the clevis, then insert the clevis pin into the desired
hole in the control horn.
3. Move the tube to hold the clevis on the control horn
A
B
tooltip
C
E
R
Wing Installation
1. Slide the wing tube (
A
) into the fuselage.
2. Install the left and right wing over the wing tube.
3. Guide the LED connectors
(B
) from both wings into the fuse and toward the
bottom hatch.
4. Seat the wings in the slot of the fuselage. Be careful not to pinch any wires.
5. Secure the wings to the fuselage using the included 2 screws (
C
) as shown.
6. Connect the LED connectors to the connector block as shown. The LED
connectors can be in any port of the block.
Disassemble in reverse order.
A
B
C
EN
5
Model Assembly
