Settings
For maximum cleaning performance,
the following carpet height settings are
recommended.
Lowest setting:
for bare floors and all
types of carpet
Note:
If the cleaner is difficult to push,
slide knob to the next higher setting.
Higher settings:
for very deep
pile carpet where easier pushing effort is
desired, while maintaining good cleaning
performance.
Cleaning lightweight
flexible rugs
Stand on one end of rug and move
cleaner toward other end or edge.
Before reaching edge, push down on
handle. This will lift up the nozzle (front
of cleaner) and will prevent rug from
clinging to cleaner. Continue to lift up
nozzle so that when you have reached
the edge, it is completely off the rug.
Move cleaner back to start again, lower
nozzle, and use only forward strokes.
6
Carpet height
adjustment
The cleaning of carpet and rugs takes
place at the nozzle (B).
When it is necessary to raise and lower the
nozzle for various carpet pile heights, slide
the nozzle control knob (C) to the desired
setting.
Handle position
For ease in sliding knob, place handle in
the upright position and tilt cleaner
backward.
Edge cleaning
Special edge groomers are provided on
both sides of the nozzle to remove dirt in
carpet near baseboards and furniture.
Guide either side of nozzle parallel to
edge of carpet or furniture.
2-5
B
C
2-10
Brush roll switch
Turn brush roll switch (D) OFF to clean
hard surface floors.
Turn brush roll switch ON to clean carpet
and rugs.
The brush rolls will automatically turn off
when the handle is in the upright
position.
Circuit breaker
The circuit breaker turns off the brush
rolls if there is an obstruction in them.
When tripped, the circuit breaker button
(E) will pop up and the brush roll control
button will light up.
The brush rolls will not turn, but the suc-
tion motor
will continue to run.
To reset the breaker, turn cleaner OFF
and unplug it. Clear obstruction. Press
circuit breaker button down. Turn
cleaner ON and continue cleaning.
2-6
2-7
2-8
D
E
2-9
