6
23
B
A
C
D
24
24
For ease in sliding knob, the handle
should be in the upright position
(C).
The nozzle will not move into the
adjusted position until the cleaner
handle is lowered to the operating
position (D).
23
The cleaning of carpet and rugs
takes place at the nozzle (A).
When it is necessary to raise and lower
the nozzle for various carpet pile
heights, slide the nozzle control knob (B)
to the desired setting.
Carpet height
adjustment
25
HARD
FLOOR
25
For maximum cleaning perfor-
mance,
the following carpet height
settings are recommended:
• Lowest setting (5): for all types of
carpet
• Higher settings (1-4): for very deep pile
carpet where easier pushing effort is
desired, while maintaining good cleaning
performance.
Note: If the cleaner is difficult to push,
slide knob to the next higher setting.
26
Cleaning lightweight
flexible rugs
Stand on one end of rug and move
cleaner toward other end or edge.
Before reaching edge, push down on
handle. This will lift up the nozzle (front of
cleaner) as shown and will prevent rug
from clinging to cleaner. Continue to lift
up nozzle so that when you have reached
the edge, it is completely off the rug.
Move cleaner back to start again, lower
nozzle, and use only forward strokes.
26
27
Edge cleaning
Special edge groomers are
provided on both sides of the
nozzle to remove dirt in carpet near
baseboards and furniture. Guide either
side of nozzle parallel to edge of carpet
or furniture.
27
Stair cleaning
A stair cleaning handle has been
designed for ease in using your
cleaner on stairs. With handle in operat-
ing position, place fingers under edge of
stair cleaning handle and guide cleaner
with other hand on upper handle.
As an alternative, you may use the hose
and furniture nozzle for stair cleaning.
Clean from bottom to top.
When using cleaning tools, the agitator
will continue to rotate.
CAUTION: To avoid personal injury or
unnecessary wear to carpet, and to
prevent the cleaner from falling, always
place it at bottom of stairs.
28
28
LONG PILE
CARPET