If a minor problem occurs, it usually can be
solved quite easily when the cause is found
by using the checklist below.
Problem: Cleaner won't run
• Filter bag full
•
Change filter bag
• Incorrect carpet height setting
•
Move nozzle control knob to lower
setting
• Blockage in air flow passage
•
Clear blockage
Possible Cause
Possible Solution
• Broken or worn belt
•
Replace belt
• Agitator brush roll worn
•
Replace brush roll
Problem: Cleaner / tools won't pick up
Problem: Cleaner hard to push
Lubrication
The motor is equipped with bearings that
contain sufficient lubrication for the life of
the motor. The addition of lubricant
could cause damage.
Therefore, do
not add lubricant to motor bearings.
The agitator is equipped with two ball
bearings that should be lubricated
periodically by a Hoover Service Center
or an Authorised Hoover Service Dealer.
Service
Spares and Service
When service is required, contact your
Hoover dealer. Replacement spare
parts, cloth bags, belts, brushes, etc.
can be readily supplied by your Hoover
dealer. Always quote your cleaner model
number when ordering spare parts. Use
only spare parts supplied by Hoover to
ensure that your cleaner operates at
maximum efficiency.
IMPORTANT
Cord Replacement
This HOOVER appliance is supplied
complete with a plug.
If the main cord of this appliance is
damaged, the appliance must be
repaired by an Authorised Hoover
Repairer to avoid a safety hazard.
If you have a
problem
Possible Cause
Possible Solution
• Incorrect carpet height setting
•
Move nozzle control knob to a higher
setting
Possible Cause
Possible Solution
• Not firmly plugged in
•
Plug unit in firmly
• No voltage in wall plug
•
Check fuse or breaker
• Blown fuse or tripped breaker
•
Replace fuse or reset breaker
• Thermal protector activated
•
Allow cleaner to cool for 30 minutes
(this will reset the thermal protector)
13
*HOOVER and are registered trademarks