background image

5.

When using your vacuum cleaner, basic 
precautions should always be observed, including 
the following;
1.  This appliance is not intended for use by 

persons (including children) with reduced 
physical, sensory or mental capabilities 
or lack of experience and knowledge, 
unless they have been given supervision or 
instruction concerning use of the appliance 
by a person responsible for their safety.

2.  Children should be supervised to ensure 

that they 

do not

 play with the appliance.

3.  To prevent electrical shock, 

do not

 immerse 

the appliance, power cord or power plug 
into water or other liquids.

4.  To prevent electrical shock, 

do not

 

use the vacuum cleaner outdoors or 
on wet surfaces.

5.  Always check the power cord before use, 

the power cord and the plug should be in a 
good condition and 

must not

 be damaged. 

If the power supply cord is damaged 
or defective, it must be replaced by the 
manufacturer, its service agent or similarly 
qualified persons in order to avoid a hazard.

6. 

Do not

 unplug by pulling on the power cord. 

To unplug, grasp the plug not the power 
cord. Use only Australian and New Zealand 
electrical safety approved extension cords.

7. 

Do not

 pull or carry the appliance by the 

power cable, use the power cable as a 
handle or pull the power cable around 
sharp edges or corners. Avoid running the 
appliance over the power cable.

8.  Ensure the appliance is switched off 

before unplugging.

9. 

Do not

 handle or operate the appliance 

with wet hands and follow electrical safety 
precautions at all times.

10.  Extreme caution should be exercised when 

using the appliance on stairs.

11. 

Do not

 attempt to change the attachments 

while the appliance is plugged in to mains 
power supply. Switch off and remove 
plug from mains power supply. Use only 
manufacturer’s recommended accessories.

12. 

Do not

 operate the vacuum cleaner too 

close to the heaters, radiators and other 
hot surfaces.

Safety Precautions & Warnings

IMPORTANT! Always switch off the cleaner and remove the plug from the 

electricity power supply before cleaning your appliance, when not in use or 

attempting any maintenance task. The cleaner must only be connected to an 

AC power supply at the voltage shown on the rating label. This cleaner should 

only be used for its intended purpose as described in this instruction manual. 

Never operate the vacuum cleaner without filters.

Before Y

ou Begin

Summary of Contents for smart R1













Reviews: