Inspecting the Belt
The Turbine Hand Tool Belt is designed to last a
long time and is not normally replaced. However,
if the Belt is cracked, gouged or broken, it should
be replaced.
5.22
Remove Tool from Hose and turn it so bottom
faces up. Press the Latches on either side of
Tool and remove Bottom Plate (A).
Replacing Belt
5.23
Remove Bottom Plate, Belt Guard and Brushroll
as described in Figs. 5.17 through 5.19.
Grasp Turbine (E) and pull firmly to remove.
Remove Belt (F) from Turbine Pulley.
Replace with new Belt.
5.24
With flat sides of Turbine Retainers (G) pointing
down, slide Retainers into grooves (H) on both
sides of Tool Housing and snap into place.
Replace Brushroll, Belt Guard, and Bottom
Plate as described in Figs. 5.19 through 5.21.
Turbine Hand Tool
5.23
F
E
5.24
G
H
What to Buy
To assure cleaning effectiveness, use only
Hoover
®
Belt #38528037.
It is important that you use only genuine HOOVER
®
parts
to assure your cleaner operates at peak performance. To
order Filters please visit www.hoover.com. HOOVER
®
parts
can be identified by the trademark-
GENERAL
MAINTENANCE
5. GENERAL MAINTENANCE
A
5.22
17
