9
Cleaning bare floors
Some models come with the bare floor attachment. For others,
the attachment is available at additional cost from your Autho-
rized Hoover Dealer (Depot) or Hoover Factory Service Center.
TANK
HANDLE
How to attach bare floor attachment
Disconnect deep cleaner from electrical outlet.
To prevent possible leaking, remove clean solution tank by
pressing down on tank handle and pulling forward; set tank
aside (do not set tank on furniture.)
LATCH
HANDLE
RELEASE
PEDAL
Step on handle release pedal and lower handle until it rests on
the floor.
Rotate recovery tank latches outward (one on each side of
tank). Lift tank off machine.
With handle in the upright position, tilt deep cleaner back so that
handle rests on the floor.
Place attachment on front of nozzle with foam strip (under
netting) in position as shown.
LATCH
Lower handle and replace recovery tank. Press down to ensure
that it is properly seated in place.
Rotate latches (one on each side of tank) inward to lock
tank in place. Raise handle to upright position and replace
upper clean solution tank.
Push attachment against nozzle while rotating attachment
downward until both ends “snap” into place.
(Note: Some force may be required to rotate and snap
attachment into place.)
Return deep cleaner to upright position.
To clean floor
Read “Before you begin cleaning” instructions on page 7.
Do not use deep cleaner on hardwood floors.
Fill clean solution tank according to instructions on pages 5-6.
Use 5 ounces of HOOVER Bare Floor Cleaner.
Do not use any
type of wax with your deep cleaner.
Dry hands and plug deep cleaner into a
properly grounded
outlet.
Step on handle release pedal and lower handle to operating
position. Turn deep cleaner ON.
To release solution, squeeze trigger. Slowly move deep cleaner
forward and backward over area to be cleaned.
To pick up dirty solution, release trigger and slowly move deep
cleaner over area where solution has just been dispersed. Use
both forward and reverse strokes.
When finished cleaning, follow “After cleaning” instructions on
page 8.
Remove attachment from nozzle and rinse in clear water. Do not
remove plastic screen or foam from attachment.
Using the stair/upholstery nozzle
TANK
HANDLE
Disconnect deep cleaner from electrical outlet.
How to attach hose
Continued
➜
To prevent possible leaking, remove clean solution tank by
pressing down on tank handle and pulling forward; set tank
aside (do not set tank on furniture).
NOZZLE
FOAM STRIP
