5
To transport
Turn deep cleaner off before transporting.
To move your deep cleaner from room to room, put handle in
upright and locked position, tilt deep cleaner back on wheels,
and push forward.
Step on pedal to lower handle to operating position. Handle
does not lock into a single position but “floats” to allow conve-
nient operation.
When the recovery tank (lower tank) is full, the automatic “shut-
off” mechanism will shut off the deep cleaner suction.
When this happens, the red float disk will rise to the top of the
recovery tank lid (see illustration). The deep cleaner will no
longer pick up dirty solution and the motor sound will become
noticeably higher in pitch.
When this happens, turn deep cleaner off
and empty recovery
tank before continuing use.
ON/OFF pedal
Handle release pedal
Automatic “shut-off”
ON/OFF
PEDAL
HANDLE
RELEASE
PEDAL
FLOAT DISK
How to fill
TANK
HANDLE
Place handle in the upright, locked position.
Carry tank to a sink.
Rotate tank cap counterclockwise and lift up to remove cap.
Continued
➜
To remove tank, press down on handle and pull forward.
Clean solution tank (upper tank)
General operation
The deep cleaner may also be lifted by placing a hand under
the upper clean solution tank handle as shown.
The tanks
The clean solution tank holds the cleaning solution that is to be
dispersed onto the surface to be cleaned.
Operate deep cleaner only at voltage specified on data plate
on back of cleaner.
Plug deep cleaner into a properly grounded outlet.
Step on pedal to turn deep cleaner on. Step on pedal again to
turn deep cleaner off.
Disconnect deep cleaner from electrical outlet.
Check clean solution tank also; it may need to be refilled.
