Hoover BRUSH N WASH, Instructions Manual

Page: 8 / 43

25
Turn cap (B) upside down to
serve as a measuring cup.
150 ml
B
E
D
26
27
28
29
Using cap, measure detergent following
the chart below.
For carpet, carpeted stairs and uphol-
stery:
Fill cap to
fill line
(150 ml) with HOOVER
Carpet/Upholstery Detergent.
For bare floors:
Fill cap to
fill line
(150 ml) with HOOVER
Bare Floor Cleaner *
Do not use Bare Floor Cleaner on carpet or
upholstery.
Do not use any type of wax
with your cleaner.
NOTE: Use only HOOVER detergents.
They are specially formulated for use
with your cleaner.
*Available at additional cost if not included
with your model.
CAUTION: Detergents contain
Anionic and Nonionic Surfactants.
Avoid contact with eyes and skin. In
case of contact with eyes, flush with
cold water for 15 minutes. In case of
contact with skin, wash with water. If
Irritation persists, call a physician.
Pour detergent into tank. Fill
tank to fill line (C) (3.78 l) with
hot tap water.
To assure proper performance,
use only
HOOVER cleaning detergent.
C
If rubber ring (D) on cap has
become dislodged, reposition it
with uneven side against ledge (E) as
shown.
Replace cap.
Rotate cap clock-
wise until it locks in place. Cap
must be locked in place for proper
performance and to prevent leaking.
Position bottom of tank into unit
and press on tank handle to snap
tank into place.
Recovery tank
(lower tank)
The recovery tank holds the dirty solu-
tion that is picked up from the carpet.
When the recovery tank is full, the auto-
matic shut-off will engage (see page 6)
and the tank must be emptied.
How to empty
Turn cleaner off and unplug from elec-
trical socket.
To prevent possible leaking, remove
clean solution tank (Fig. 23) by pressing
down on tank handle and pulling for-
ward; set tank aside
(do not set tank
on furniture).
For heavy traffic areas:
Pre-treat with HOOVER PreCleaner
Spray.
If you do not have access to the
PreCleaner Spray, double the amount
of HOOVER Detergent (use 2 capfuls
or 300 ml per 3.78 l tank).
8
25
26
27
28
29