Honeywell Stratos 2700, User Manual

Page: 34 / 278

2 - 14
The images from the video camera are shown in the upper left corner of the scanner’s vertical tower.
Connecting EAS
Checkpoint®
When connecting to a Checkpoint EAS system, connect the Checkpoint EAS interlock cable (if required) to the EAS inter-
lock port on the left side of the 2700 (see
Device Ports on page 2-8). Connect the Checkpoint antenna cable to the antenna
port on the underside of the 2700, shown above. Refer to EAS Settings beginning on page 10-1 for configuration codes
and further EAS programming information.
Sensormatic®
When connecting to a Sensormatic EAS system, connect the Sensormatic RS232 control line to the EAS interlock port on
the left side of the 2700 (see
Device Ports on page 2-8). Connect the Sensormatic antenna cables to the to the multi-col-
ored antenna connectors on the underside of the 2700, shown above. Contact Tyco for further information about Sensor-
matic installation and configuration. Refer to
EAS Settings beginning on page 10-1 for Stratos bioptic configuration codes
and further EAS programming information.
Connecting to the POS System
Step 1. Turn off the host system.
Step 2. If using a single cable, plug one end of the interface cable into the port labeled for your interface on the right side
of the Stratos bioptic:
USB:
Scanner USB to Host
RS232: Scanner RS232 to Host
RS485: Scanner RS232 to Host
When using a dual cable, plug an RS232 cable into the Scale to Host port on the right side of the Stratos bioptic.
(Internal)
Scale Displa
y In
(Internal)
Scale C
om In
Aux RS232 I
n EAS I
nterlock
AUX USB I
n
Came
ra
Video I
n
Came
ra
+12V Out
Checkpoint EAS Antenna Port
Sensormatic
Antenna
Connectors