VISIOCAM
69-2108EFS—01
Installing the door camera
Position the receiver
The receiver must be positioned within range of the door camera (i.e. less than 60 ft.
(20 m) in a typical building).
Test the system
To ensure reliable operation, we recommend that both the door camera and receiver
are powered up in their planned position(s), to check that the receiver has a good sig-
nal from the door camera.
To test the system, have someone hold the door
camera against the wall in the selected mounting
position and press the call button, while you check
the reception on the receiver unit.
If the picture quality is poor, or there is no response
when the call button is pressed, then there are three
possible reasons:
1. The units may be too far apart (more than 60–90 ft. [20–30 m] in a typical house).
Try moving the receiver closer.
2. There is nearby interference on the video channel. Remove the door camera
back and change the video channel switch from CH 1 to, for example, CH 3. Test
the system again, selecting a different channel if channel 3 is no better.
Refer to the troubleshooting section for more information on interference reduction.
3. The door camera has not been programmed into the receiver (refer to page 3).
Adjust the camera angle
With the door camera at the intended position, you may need to
adjust the camera lens to cover the desired observation area.
Open the back of the door camera and adjust the camera eyeball
from the back of the product. Note that there is more camera move-
ment available in the Up/Down than in the Left/Right direction.
69-2108EFS_A.indd 5
11/30/2007 1:51:47 PM
