background image

Notifier

®

 and FlashScan

®

 are registered trademarks of Honeywell International, Inc. Testifire

®

 is a registrered trademark of SDi, LLC. 

DEVICE AND SYSTEM SECURITY

Before installing this product ensure that the 
tamper seal on the packaging is present and 
unbroken and the product has not been tampered 
with since leaving the factory. Do not install this 
product if there are any indications of tampering. 
If there are any signs of tampering the product 
should be returned to the point of purchase.
It is the responsibility of the system owner to 
ensure that all system components, i.e. devices, 
panels, wiring etc., are adequately protected to 
avoid tampering of the system that could result 
in information disclosure, spoofing, and integrity 
violation.

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired 
operation.

WARNING:

 Do not make changes to the equipment. Changes or modifications not expressly approved 

by the manufacturer could void the user’s authority to operate the equipment.

SUPPLEMENTAL INFORMATION

For Limitations of Fire Alarm Systems, 

please go to: 

http://www.systemsensor.com/

en-us/Documents/I56-1558.pdf  

 

Limitations of  

Fire Alarm Systems

  4 

I56-6783-000 

  

©2021 Notifier. 1/6/2021

Summary of Contents for NOTIFIER FSP-951T-SELFT

Page 1: ... condensing Operating Temperature Range 32 F to 115 F 0 C to 47 C Storage Temperature Range 4 F to 140 F 20 C to 60 C Air Velocity 0 to 4000 ft min 0 to 1219 2 m min Air Velocity using Self Test 0 to 300 ft min 0 to 304 8 m min Height 2 0 51 mm installed in B300 6 Base Diameter 6 2 156 mm installed in B300 6 Base 4 1 104 mm installed in B501 Series Base Weight 3 5 oz 100 g Isolator Load Rating 0 0...

Page 2: ...ne you must verify the completion of the visual inspection of the sensor via the App recording any remedial action required if necessary Criteria for success fully passing the visual inspections is available to review in the relevant section of NFPA 72 guidance 4 If the label of the self test sensor is incorrect you can update this on the App subject to holding the relevant user licence which will...

Page 3: ...CATION When configured at the fire alarm control panel this detector is capable of op erating in a special application mode such that it has a higher sensitivity than is normally allowed by UL 268 for areas where early warning is important In this mode the detector does not comply with the Cooking Nuisance Smoke Test Detectors Sampling ports set to the special application mode are not suitable for...

Page 4: ...g etc are adequately protected to avoid tampering of the system that could result in information disclosure spoofing and integrity violation FCC STATEMENT This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 This device must accept any interference received including interference that may caus...

Reviews: