
Appendix C
Remote Control
Remote Control for Daisychained Multiplexers
If you are using a computer to control two or more daisy-chained
multiplexers, you need to send a re-address command to select the
multiplexer to control. (Up to 16 multiplexers can be daisy-chained.)
Re-address commands are not printable characters; you need an 8-bit
binary address or hex value to select which daisy-chained multiplexer
you control. If you lose power to one or more multiplexers, you will need
to use the re-address command again to select the correct multiplexer.
HEX
RESULTS
HEX
RESULTS
00
NUL (changes active multiplexer)
09
9 (9th connected multiplexer)
01
1 (1st connected multiplexer)
0A
10 (10th connected multiplexer)
02
2 (2nd connected multiplexer)
0B
11 (11th connected multiplexer)
03
3 (3rd connected multiplexer)
0C 12 (12th connected multiplexer)
04
4 (4th connected multiplexer)
0D 13 (13th connected multiplexer)
05
5 (5th connected multiplexer)
0E
14 (14th connected multiplexer)
06
6 (6th connected multiplexer)
0F
15 (15th connected multiplexer)
07
7 (7th connected multiplexer)
10
16 (16th connected multiplexer)
08
8 (8th connected multiplexer)
< Table 1 >
Re-Address Commands
74
Summary of Contents for HXMT9
