50403/SA2/1305
HERMetic Sampler A2
4
3. General information
3.1 Shipment note
The following parts should be included in the
shipment:
- 1 instrument;
- One or more bottles as ordered;
- 1 Allen key 5mm
- 1 Operation and Service Manual.
3.2 Initial inspection
Check the contents of the shipment for
completeness and note whether any damage
has occurred during transport. Carry out the
“Initial test before installing the instrument” to
verify the good functioning. If the contents are
incomplete, or if there is damage, do not use
the device. A claim should be filled with the
carrier immediately, and Enraf Tanksystem
SA Sales or Service organization should be
notified in order to facilitate the repair or
replacement of the instrument.
3.3 Documentation discrepancies
The design of the instrument is subject to
continuous development and improvement.
Consequently,
the
instrument
may
incorporate minor changes in detail from the
information contained in the manual.
3.4 Warranty
12 months after installation but max. 18
months after delivery ex works.
The Vendor undertakes to remedy any
defect
resulting
from
faulty
design
materials or workmanship. The Vendor's
obligation is limited to the repair or
replacement of such defective parts by his
own plant or one of his authorized service
stations. The Purchaser shall bear the
cost and risk of transportation of
defective
parts
and
repaired
parts
supplied in replacement of such defective
parts.
When returned to Enraf Tanksystem SA or
any of its agreed Service Stations
equipment must be contamination-free. If
it is determined that the Purchasers
equipment is contaminated, it will be
returned
to
the
Purchaser
at
the
Purchasers
expense.
Contaminated
equipment will not be repaired, replaced,
or covered under any warranty until such
time
that
the
said
equipment
is
decontaminated by the Purchaser.
The Purchaser shall notify by fax, telex or in
writing of any defect immediately upon
discovery,
specifying the nature of the defect
and/or the extend of the damage caused
thereby.
Where no other conditions have been
negotiated between the Vendor and the
Purchaser "General Conditions 188" of
United Nations shall apply.
This equipment has been certified as non-
electrical equipment for potentially explosive
atmospheres for only those classes or
categories of hazardous areas stated on the
instrument label, bearing the mark of the
applicable approval authority. No other usage
is authorized.
Unauthorized
repair
or
component
replacement by non original spare parts by
the Purchaser will void this guarantee and
may impair the good functioning of the
instrument.
In no event shall Enraf Tanksystem SA be
liable for indirect, incidental or consequential
loss or damage or failure of any kind
connected with the use if its products or
failure of its products to function or operate
properly.
Enraf Tanksystem SA do not assume the
indemnification for any accident or damage
caused by the operation of its product and
the warranty is limited to the replacement of
parts or complete goods.
