Honeywell HERMetic, Operation And Service Manual

Page: 18 / 36

50403/SA2/1305 18 HERMetic Sampler A2
7.4 Tape cleaning
If tape requires cleaning it has to be unwound. Clean it during its winding-up operation on the
winder.
7.5 Tape wiper replacement

Unscrew the 4 screws position 7 on the drawing ND 20319 (30m) or ND 40796 (40m)

Remove the old tape wiper.

Put the new one.

Tighten the 4 screws again.
7.6 Tape replacement

Remove the winder holder from the sampler (2 screws);

Remove the tape wiper;

Unwind totally the old tape;

Remove it and unscrew the screw tightening to the core;

Put the new tape;

Fasten the tape to the core with the screw;

Wind the new tape;

Put back the tape wiper.

Put back the winder holder and tighten the 2 screws.
7.7 Storage of HERMetic devices
For a proper storage of HERMetic products (UTImeter, Sampler, Thermometer and related spare-
parts…), we recommend:
-
Clean the devices after use,
-
• Remove batteries for prolonged storage,
-
• Store batteries in a dry and cold location,
-
• Store the goods in a safe, dry and dust free location with an ambient temperature
b5°C to +45°C.
7.8 Transportation of HERMetic devices
For transportation of the device, always strecht out the tape to avoid any move of the the bottle
inside its storage tube.
7.9 Recycling of HERMetic devices
Equipment does not contain any dangerous materials inside which can harm the environment and
people health during normal use or disposal. However the utilization and recycling of the
equipment after the end of its life must be implemented by an authorized organization in
accordance to local legislation.