Honeywell HEN04102, User Manual

Page: 105 / 180

Configuring Event Settings | 105
800-21090V2 - A - 03/2016
Figure 8-5 Motion Detection Configuration Tab
2. On the Motion Detect tab, select the actions that you want the system to initiate when a
motion detection event occurs:
3. Click Apply to save your settings.
• Alarm Out Select the alarm output(s) ( 1 or 2 ) that you want to activate. In the Latch
box, specify the amount of time (1–300 s) to delay the alarm output
signal after a motion detection event is triggered.
• Show Message Select the check box to enable a pop-up message on your local host PC.
• Alarm Upload Select the check box to enable the system to upload an alarm signal to
the network (including to an alarm center and/or web client).
• Send Email Select the check box to enable the system to send an email notification.
If the
Snapshot function is enabled, an image can be attached to the
email.
• Record Channel Select the channel(s) that you want to record. In the Delay box, specify
the amount of time (1–300 s) to delay recording after a motion detection
event is triggered.
Note You also need to set the motion detection recording period.
Go to
Storage > Schedule to configure the current channel
for scheduled recording. See Configuring the Video
Recording Schedule on page 63.
• PTZ Activation Select the check box to activate PTZ functions, and then click Select . In
the PTZ Activation window, for each PTZ camera, select the preset,
tour, or pattern that you want to be called when a motion detection event
occurs, and then click
OK .
• Tour Select the check box to enable a tour of the selected channels.
• Snapshot Select the check box to take a snaphot of selected channels.
• Buzzer Select the check box to activate a buzzer noise at the NVR.