Honeywell HCC484TP, User Manual

Page: 12 / 196

Rev 1.01 4 900.0512
07/06
Figure 3 Auto Iris Lens Pin Definition
3. Set the EE MODE to ALC MODE on the OSD menu (see ELC /
ALC Mode on page 13 ).
Auto iris lens with amplifier: Set the VSD LENS on the OSD
menu.
Auto iris lens with no amplifier: Set the DC LENS on the OSD
menu. Adjust to the LEVEL carefully to avoid hunting.
4. Set the switch on the rear of the camera to DC or VSD.
Auto iris lens: Use the connection recommended by the
manufacturer. For best practices, read the lens manual
carefully. You may need to set the flange back focus.
Pin DC (Direct Drive) lens Video (VSD) lens
1 CTRL - Power (+12V)
2 CTRL + NC
3 DRV + Video Signal
4 DRV - GND
2 1
4 3
4-pin lens terminal
+
VIDEO
DOW N
M ENU
UP
-
DC
VSD
CONT
CV
Set to VSD for an auto iris lens with a built-
in amplifier (video-type lens).
Set to DC for an auto iris lens without an
amplifier (DC-type lens).
Video Output Selection Switch:
Set to CV for Composite Video.
Set to TP for UTP Video.