9000-0447 Rev. I
Page 9 of 42
2.0 Installation
2.1 General
Components are ordered and shipped in separate packaging for the enclosure and Basic
System Module kit. The 7100 is intended for installation indoors, in a dry location. The
shipping carton contains an installation drawing, backbox, Basic System Module (BSM),
power transformer and door.
1) Refer to the System Assembly Drawing, P/N 9000-0457.
2) The BSM module consists of a main operating board with pluggable terminal strips, an
80-character LCD display and programming keypad. Install this module immediately
unless any optional modules are to be used in the system. The optional modules are
supplied separately, and should be installed on the BSM before it is mounted in the
backbox. Before installing the BSM into the system backbox, refer to the installation
instruction sheets shipped with each module for the proper installation procedures.
3) Install the transformer into the backbox. Connect the transformer to the BSM.
4) Install the door after the BSM is in place.
Note that the door can only be installed (or removed) when it is opened at least 90
°
from the backbox.
