23 |
P a g e
LEG SETUP FOR FRONT AND SEE-THROUGH UNITS
•
Step1 - Release the pin.
•
Step2
–
Release the 2 screws from the leg.
•
Step 3
–
Extend the telescopic leg to the desired length, minimum 4” (That will set the fireplace 10” from the
bottom of the glass to the floor).
•
Step 4
–
Retighten the three screws to secure the telescopic leg in position. Note that the top pin inserts into
the holes only for alignment. The two bottom screws tighten down on the legs.
•
Step 5
–
Repeat Steps 1-4 for each on the fireplace so that they are all extended to the same length.
•
Step 6
–
Stand the fireplace up and fine tune the feet with the wrench included so the fireplace is level. Open
the screws to raise the fireplace. Close the screws to lower the fireplace.
Step 1
Step 2
Step
3
Step 4