Honeywell FDAP3P, Manual

Page: 60 / 96

4 FDAP CONFIGURATION
50 www.honeywell.com
4. In the Modbus Interface list, click the required option. The following
are the interface options available.
•
Modbus RTU
•
Modbus TCP
Attention
Based on the connected Modbus devices, select the appropriate option.
5. Configure one of the following depending on the Modbus interface option that you have selected.
•
If you have selected Modbus TCP Interface, configure the following under Modbus TCP Settings .
o
FEWIO IP Addr : IP address that needs to be assigned to FEWIO and the IP address Subnet
should be same as the IP address of slaves.
o
Subnet Mask : Subnet Mask
o
Gateway: Gateway IP address.
o
Slave1 IP Addr : IP address of Slave1
o
Slave2 IP Addr : IP address of Slave2
o
Slave3 IP Addr : IP address of Slave3
o
Slave1 UnitID : Unit ID of Slave1 used for the Modbus TCP port.
o
Slave2 UnitID : Unit ID of Slave2 used for the Modbus TCP port.
o
Slave3 UnitID : Unit ID of Slave3 used for the Modbus TCP port.
•
If you have selected Modbus RTU Interface, configure the following under Modbus RTU Settings .
o
Baud Rate: Select the baud rate used for the Modbus RTU serial port. Options include:
9600,19200, 38400, 57600, 11520 .
o
Parity: The parity used for the Modbus RTU serial port. Options include: Even and Odd .
o
Stop Bits: Options include: 1 and 2 .