Assembly Instructions
6
Page 72 of 120
Operating Instructions
enCore FC
Hints on parameterization
Branch
<device> – Basic System – I/O boards –
Board <x>: MFE7
Set the following values:
•
channel
A1+ A1−
or
A2+ A2−
: type
HART channel
•
parameter
Power supply
: value
Off
(sink mode)
With this, the operating mode of the channel is set correctly for
connectingthe HART transmitters.
If you are using the basic system version
03-24
and earlier, refer
to
FAQ 11.2 Limitations for multidrop and burst mode up to basic
(p. 116).