6
USE & OPERATION (CONTINUED)
EN
CLEANING THE CARBON DUST FILTER* AND HONEYCOMB COOLING MEDIA
The appliance is supplied with a Carbon Dust Filter* and Honeycomb Cooling Media.
The Carbon Filter* and Honeycomb Cooling Media are located inside the Rear Grill. See Figure 1
for instructions on how to remove them from the unit for cleaning and maintenance.
Do not run the unit in COOL mode with stale water in the tank. You must empty the water tank
and refill with fresh water, especially if the tank has not been cleaned in a long time.
The cleaning frequency for the Honeycomb media depends on local air and water conditions.
In areas where the mineral content of water is high, mineral deposits may build up on the
Honeycomb Cooling Media and restrict air flow. Draining the water tank and refilling with fresh
water at least once a week will help reduce mineral deposits. If mineral deposits remain on the
Honeycomb Cooling Media, the media should be removed and washed under fresh water. The
media should be cleaned every two months or sooner, depending on your needs.
For best results allow the Honeycomb Cooling Media to dry after each use by turning off the cool
function 15 minutes before turning the unit off.
•
•
•
•
•
Press the Release Button located at the top of the unit, to open the Ice Compartment Lid.
Remove the water tank from the unit.
Remove all screws from the Rear Grill.
Press the Release Button and at the same time, pull the Rear Grill away from the cooler.
Remove the Carbon Filter* and clean with Water.
Locate the Water Collection Tray & Tube secured to the bottom of the Rear Grill. Remove the 2
screws to release the Water Collection Tray & Tube. Put aside.
Slide out the Honeycomb Cooling Media. Replace or clean media with water and a damp cloth as
needed.
When finished, replace & secure the new or cleaned Honeycomb Media and Water Collection Tray
& Tube back onto the Rear Grill.
Replace the Rear Grill by sliding it into the back side of the unit. Note that the Release Button
must be pushed down and latched onto the top of the Rear Grill in order to replace the Rear Grill
properly back onto the unit.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Removing the Carbon Dust Filter*/ Honeycomb Cooling Media:
WARNING:
DO NOT operate the Air Cooler when the Rear Grill is removed from the Air Cooler, or if
there is a loose-fitting Rear Grill. Doing so can cause serious injury or dangerous electrical shock.
*Applicable for models with Carbon Dust Filter only.
ON/OFF
MODE
TIMER
SPEED
SWING
AIR COOLER/HUMIDIFIER/AIR PURIFIER
Figure 1:
Honeycomb
Cooling Media
Honeycomb
Frame
Carbon Dust
Filter
Water Tank
Screws
Rear Grill
Rear Grill
Release Button
