Honeywell ADEMCO VISTA SERIES, Programming Manual, Page: 42 / 48

FCC STATEMENTS
FEDERAL COMMUNICATIONS COMMISSION (FCC) Part 15
The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual.
Unauthorized changes or modifications could void the user's authority to operate the equipment.
CLASS B DIGITAL DEVICE STATEMENT
This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following statement for
your information:
This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the
manufacturer's instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the
limits for a Class B computing device in accordance with the specifications in Part 15 of FCC Rules, which are designed to provide
reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• If using an indoor antenna, have a quality outdoor antenna installed.
• Reorient the receiving antenna until interference is reduced or eliminated.
• Move the radio or television receiver away from the receiver/control.
• Move the antenna leads away from any wire runs to the receiver/control.
• Plug the receiver/control into a different outlet so that it and the radio or television receiver are on different branch circuits.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil num é rique de la classe B est conforme à la norme NMB-003 du Canada.
FCC/IC STATEMENT
This device complies with Part 15 of the FCC rules and RSS 210 of Industry Canada. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may
cause undesired operation.
Cet appareil est conforme
à la partie 15 des r è gles de la FCC & de RSS 210 des Industries Canada. Son fonctionnement est soumis aux
conditions suivantes: (1) Cet appareil ne doit pas causer d' interferences nuisibles. (2) Cet appareil doit accepter toute interference re ç ue y
compris les interferences causant une reception ind é sirable.
TELEPHONE/MODEM INTERFACE
FCC Part 68
This equipment complies with Part 68 of the FCC rules. On the front cover of this equipment is a label that contains the FCC registration
number and Ringer Equivalence Number (REN). You must provide this information to the telephone company when requested.
This equipment uses the following USOC jack: RJ31X
This equipment may not be used on telephone-company-provided coin service. Connection to party lines is subject to state tariffs. This
equipment is hearing-aid compatible.
Industry Canada
NOTICE
: The Industry Canada Label identifies certified equipment. This certification means that the equipment meets telecommunications
network protective, operational and safety requirements as prescribed in the appropriate Terminal Equipment Technical Requirements
document(s). The Department does not guarantee the equipment will operate to the user ’ s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications
company. The equipment must also be installed using an acceptable method of connection. The customer should be aware that compliance
with the above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or alterations made by the
user to this equipment, or equipment malfunctions, may give the telecommunications company to request the user to disconnect the
equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic
water pipe system, if present, are connected together, This precaution may be particularly important in rural areas.
Caution
: Users should not attempt to make such connections themselves but should contact appropriate electric inspection authority, or
electrician, as appropriate.
Ringer Equivalence Number Notice:
The
Ringer Equivalence Number
(REN) assigned to each terminal device provides an indication of the maximum number of terminals
allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to
the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5.
Industrie Canada
AVIS: l ’é tiquette d ’ Industrie Canada identifie le mat é riel homologu é . Cette é tiquette certifie que le mat é riel est conforme aux normes de
protection, d ’ exploitation et de s é curit é des r é seaux de t é l é communications, comme le prescrivent les documents concernant les exigences
techniques relatives au mat é riel terminal. Le Minist è re n ’ assure toutefois pas que le mat é riel fonctionnera à la satisfaction de l ’ utilisateur.
Avant d ’ installer ce mat é riel, l ’ utilisateur doit s ’ assurer qu ’ il est permis de le raccorder aux installations de l ’ enterprise locale de
t é l é communication. Le mat é riel doit é galement ê tre install é en suivant une m é thode accept é e da raccordement. L ’ abonn é ne doit pas oublier
qu ’ il est possible que la conformit é aux conditions é nonc é es ci-dessus n ’ emp ê che pas la d é gradation du service dans certaines situations.
Les r é parations de mat é riel nomologu é doivent ê tre coordonn é es par un repr é sentant d é sign é par le fournisseur. L ’ entreprise de
t é l é communications peut demander à l ’ utilisateur da d é brancher un appareil à la suite de r é parations ou de modifications effectu é es par
l ’ utilisateur ou à cause de mauvais fonctionnement.
Pour sa propre protection, l ’ utilisateur doit s ’ assurer que tous les fils de mise à la terre de la source d ’ energie é lectrique, de lignes
t é l é phoniques et des canalisations d ’ eau m é talliques, s ’ il y en a, sont raccord é s ensemble. Cette pr é caution est particuli è rement importante
dans les r é gions rurales.
Avertissement : L ’ utilisateur ne doit pas tenter de faire ces raccordements lui-m ê me; il doit avoir racours à un service d ’ inspection des
installations é lectriques, ou à un é lectricien, selon le cas.
AVIS : L ’ indice d ’é quivalence de la sonnerie (IES) assign é à chaque dispositif terminal indique le nombre maximal de terminaux qui
peuvent ê tre raccord é s à une interface. La terminaison d ’ une interface t é l é phonique peut consister en une combinaison de quelques
dispositifs, à la seule condition que la somme d ’ indices d ’é quivalence de la sonnerie de tous les dispositifs n ’ exc è de pas 5.
– 42 –