Honeywell 8812309S, User Manual, Page: 8 / 28

6
Right handed door view
Figure 9a-f
Rubber
Gasket
Control
Wire
Tailpiece
(Vertical)
Latch Hole
Figure 8a Figure 8c
C
3/4”(19mm) screw
(Optional Instalation)
Mounting Plate
7/8”(22mm) screws
Control Wire
B
Figure 10a
9. SECURING THE EXTERIOR ASSEMBLY TO THE DOOR
a. From the side marked “This side against
door”, route the Control Wire through the
rectangular slot in the Mounting Plate
(Figure 9a).
b. Place Mounting Plate against door with tailpiece passing
through the center hole in the three hole set (Figure 9b).
c. Secure the Mounting Plate to the Exterior Assembly using
two 7/8” (22mm) Screws (Figure 9c).
d. Hand tighten with a Phillips Screwdriver leaving loosely connected (Figure 9d).
e. Check that the Rubber Gasket is properly aligned and correct as necessary (Figure 8a).
f. Check vertical alignment of the lock (Figure 9f).
g. Tighten securely with a hand held Phillips Screwdriver.
DO NOT OVER TIGHTEN
10. OPTIONAL INSTALLATION
a. Using a 1/16” (2mm) drill bit, drill a pilot hole in your door using the
Mounting Plate upper hole as a guide (Figure 10a).
b. Insert one 3/4” (19mm) screw and tighten.
8. INSTALLING THE EXTERIOR ASSEMBLY
Work with the Door Open for easy access.
a. Unpack the Exterior Assembly. Use care to not scratch the green circuit board during handling and installation.
b. Check that the Rubber Gasket is properly seated on the Exterior Assembly (Figure 8a).
c. Insert the Exterior Assembly onto the door with the tailpiece going through the Deadbolt Latch Set cross
shaped spindle connector in the
VERTICAL POSITION . Route the Control Wire through the door under the
Deadbolt Latch Set (Figure 8c).
NOTE: Tailpiece must be
positioned vertically
NOTE: Lock and unlock using the key to see if
the Deadbolt Latch is opening and closing easily.
INSTALLING EXTERIOR ASSEMBLY