IQ8
Wireless transponder for wall mounting
40
FB 798941 / 10.06
11.1 Analog
loop
1. Connect the
IQ8
Wireless transponder to the analog loop of the
IQ8
Control fire alarm
system and the external power supply as described in "Installation".
2. Switch on the fire alarm control panel or the analog loop to which the
IQ8
Wireless
transponder is connected. If several
IQ8
Wireless transponders are connected, start these
up one after the other to prevent multiple assignment of one wireless device.
3. Conduct a wiring recognition of the loop with the service PC and the tools 8000
programming software. All devices on the analog loop are displayed.
4. Click the required
IQ8
Wireless transponder on this analog loop to open the dialog for
programming the wireless transponder.
5. In the menu item “Measure signal strength” check if the quality of the wireless
transmission between the transponder and the base is adequate.
6. All the wireless bases that this
IQ8
Wireless transponder has recognised are displayed in
menu item "Assign wireless devices“. If several
IQ8
Wireless transponders exist, wireless
bases that are already assigned to other
IQ8
Wireless transponders are not shown.
7. In the menu item “Assign wireless devices”, assign all required wireless bases to the
IQ8
Wireless transponder individually. The wireless devices can be assigned individually in
individual detector zones.
8. Start-up is complete for this wireless transponder. Leave the
IQ8
Wireless transponder
switched on and start up any other
IQ8
Wireless transponders that you have.
805595
IQ8
Control
IQ8
Control
esserbus
®
-PLus
Service PC
Panel
Interface
789862
Fig. 25: Commissioning
Î
Analog loop connection
