Honeywell 5010, User Manual

Page: 35 / 199

4 - 7
Manual Trigger, Low Power
Note: For RS-232 and HHLC mode only.
The imager powers down until the trigger is pulled. When the trigger is pulled,
the imager powers up and operates until there is no triggering for the time set
with the
Low Power Time-Out bar code below. There is a delay of up to one
second in operation when the imager is first triggered, but there is no delay when
operating in low power time-out mode.
Low Power Time-Out Timer
Note: For RS-232 and HHLC mode only.
Scan the Low Power Time-Out bar code to change the time-out duration (in
seconds). Then scan the time-out duration (from 0-300 seconds) from the inside
back cover, and
Save . Default = 120 seconds.
If the unit remains idle during the low power time-out interval, the unit goes into
low power mode. Whenever the trigger is enabled, the low power time-out timer
is reset.
Note: This time-out does not begin until the imager time-out setting has expired.
Snap and Ship
Snap and Ship mode allows you to bypass the decoder and ship an image
directly to the host. In this mode, an image is taken and shipped upon each
trigger pull, instead of being sent to the decoder. Snap and Ship is useful when
you are using your own decoder.
Note: Snap and Ship mode only works if the imager is connected via an RS-232
serial port or via a USB keyboard (see Plug and Play on page 2-1). If you
use Snap and Ship when the imager is connected to another interface, it
calls the decoder after each image ship, but only to look for menu codes.
Manual Trigger, Low Power
Low Power Time-Out
Snap and Ship