www.honeybeecnc.com
30
Dalian
Honeybee
CNC
Equipment
Co.,Ltd.
Tel:
+86
411
85865100
Fax:+86
411
85866100
If "
HERE POSITION
" option is selected, the system will draw the full pattern first and then draw a large
cross cursor at the piercing point. Operator may press [S] key to zoom in the pattern and observe if it is
the expected piercing position. If not satisfied, operator may press [ESC] to exit the machining mode and
take the option again.
If it is the expected piercing point, use heavy-current control switch for ignition and preheat before press
[PIERCE] key to start operation.
If "
REF POSITION
" option(Reference Point Positioning) is selected, operator should aim the cutting torch
at the reference point. After started up, the system will control the cutting torch to reach the piercing point
and then perform the operations as above.
5.10 Manual Mode and Function Window
In main menu, press
【
F2
】
to enter MAN (manual) window, as shown in picture 37 below:
Manual mode interface is same to auto mode. Differences is that now ratio value is under manual. It
influences the manual running, back speed, jog running speed, etc. Manual mode has some special
operations, as follows:
Pic. 31 Manual mode window(flame cutting operation for example)
【
↑
】
,
【
↓
】
,
【
←
】
,
【
→
】
directional control keys and
【
G
】
Continue Key
Generally, if any of the four direction keys is pressed and held, appropriate axial movement will carry on
until the key is released. However, if
【
G
】
Continue key is pressed and highlighted before any direction
key is pressed, the cutting torch will keep moving even if the key is released. The movement will not stop
until the direction key is pressed again. If two axial movements are required, let one axial movement start
first and then press the direction key for the other axial movement. Two axial movement will go on
simultaneously. In this case, the axial movement of cutting torch will stop if the corresponding direction
Active
speed
multiplying
Piercing
Kerf
Heavy
‐
current
control
Function
Input/output
indication
Machining
Parameters
Indication
Main
menu
of
manual
function
Workmode
indicating
zone
Coordinates
Shape
Display
Space
Program
