Honeybee HBST2005LCD, Operator'S Manual

Page: 29 / 52

www.honeybeecnc.com
28
Dalian Honeybee CNC Equipment Co.,Ltd.
Tel: +86 411 85865100
Fax:+86 411 85866100
After piercing, the cutting torch returns from the current position to the adjustment beginning point along a
straight line at cutting speed and continue machining along the original path without stop, which is
somewhat like extended pierced, making the piercing point more smooth.
；
3) HOLE HERE(piercing here)
After piercing, set the coordinates at current point as coordinates of "adjustment beginning point", and
continue machining along the original path to fulfill transitional piercing function.
4) Attention:
Be sure to have the system preheated sufficiently(for flame cutting) before taking steps 2) and 3) , for
piercing
operation will start right away once the operation is selected.
It is recommended to preheat the system(for flame cutting) and then press [START] key to select
appropriate operation.
Press
【
F6]
】
key to return the cutting torch along the original path, back speed can be set in
PARA—SPED-BACK SPEED.
Press
【
F
】
key to advance along the original path after returning. In the process of return, if the cutting
torch fails to reach the required position, press
【
PAUSE
】
key again and repeat the above procedure
until it reaches the right position .
In the process of return, the cutting torch will stop at G00 or a piercing point for operator to select going
on return or advancing.
The above operation can be repeated until desirable results so far.
5.8 Breakpoint Restoration Process
In case of manual pause or power off in machining operation, the system will automatically save the
current position of cutting torch as a breakpoint, which will be kept permanently in the system, whether
power the system off or not.
In automatic mode, press
【
F3
】
key to select RESBREK function and then
【
START
】
key to start
breakpoint restoration as long as there is no change with the current program.
If the position of cutting torch does not change, the system will prompt "Breakpoint" when a breakpoint is
found and wait for subsequent command. User may select piercing directly or position adjustment of
cutting torch.
If the position of cutting torch does change and is off from the breakpoint, the system will provide three
options when a program breakpoint is found, which is virtually position adjustment of cutting torch .
Pic.28 System pause, breakpoint and start again
ORI PATH RET: To return to the breakpoint at speed G00, which is often used for the breakpoint set for
cutting torch replacement;