©2006 American Honda Motor Co., Inc. - All Rights Reserved
9
7. Install the front wheel (cont.).
Make sure the axle end is flush with the front
fork leg outer surface as shown.
Tighten the left axle pinch bolts to the
specified torque.
Torque: 22 N·m (2.2 kgf·m, 16 lbf·ft)
On the ST1300A, verify the clearance between
the ABS front pulser ring and sensor.
Clearance specification:
0.4 - 1.2 mm (0.02 - 0.05 in)
If outside the clearance specification range,
recheck the wheel installation.
8. Install the mirrors.
Remove and discard the shipping bolts.
Install the right and left rear view mirrors
using two 6 x 20 mm flange bolts on
each side.
Torque the bolts.
Torque: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the two hose clips as shown.
PARTS
QTY
Right mirror cover
1
Left mirror cover
1
Right mirror cover rubber
1
Left mirror cover rubber
1
Right rear view mirror
1
Left rear view mirror
1
Flange bolt 6 x 20 mm
4
Hose clip
4
PINCH BOLTS
AXLE
0.4 - 1.2 mm (0.02 - 0.05 in)
PULSER RING
SENSOR
PULSER RING
SENSOR
6 x 20 mm FLANGE BOLTS
HOSE CLIPS
SHIPPING BOLTS
(discard)
