n
Exterior Lights
Rotate the switches on the lever to
operate the exterior lights. Push the
lever forward to turn on the high
beams. Return the lever to its original
position for low beams.
OFF: All exterior lights are off.
Turn on exterior lights except headlights.
AUTO: Turn on the automatic lighting feature. Headlights turn on or off
depending on ambient brightness when the vehicle is on.
Headlights automatically come on after the wipers are engaged for
a certain time. The headlights come on when you unlock a door in
dark areas with the headlight switch in AUTO.
Turn on all exterior lights including headlights.
Turn fog lights on or off
*1
.
One-Touch Turn Signal
Use this quick and convenient method to
signal a lane change.
Lightly push the turn signal lever up or
down for a three-blink sequence.
For a continuous signal, push the lever up
or down until it locks into place.
Auto High Beam System
*1
Automatically changes the low beam headlights to high beam headlights when
necessary.
n
How It Works
When you are driving at night above 25 mph (40 km/h) and the headlight
lever is in the low beam position with the switch rotated to AUTO, the
*1 - If equipped
VEHICLE CONTROLS
42 |
system changes between low and high beams depending on the brightness
of the vehicle lights ahead of you.
15-degrees
If a vehicle is detected ahead of you, the headlights stay in low beams. If the
system does not detect any vehicles ahead of you, the headlights change to
high beams.
Certain conditions, such as weather and brightness of other vehicles’ lights,
can affect system operation.
n
Turning the System On or Off
Make sure the headlight lever is in the low beam position with the switch
rotated to the AUTO position.
The auto high beam system indicator
comes on.
To disable the system: Pull and hold the
headlight lever toward you for about 40
seconds, until the indicator flashes
twice.
To enable the system: Pull and hold the
headlight lever toward you for about 30
seconds, until the indicator flashes
once.
To temporarily cancel operation, do either of the following:
• Flash the high beams by moving the lever toward you. Flash the high
beams again to resume auto high beam operation.
• Engage high beams by moving the lever into the high beam position.
Return the lever to the low beam position to resume auto high beam
operation.
If you find the timing of beam changes inconvenient for driving, change the
beams manually.
For the system to work properly:
• Do not place an object that reflects light on the dashboard.
VEHICLE CONTROLS
| 43