−
−
−
−
−
×
−
−
49
59 N·m
(5.0
6.0 kgf·m , 36
43 lbf·ft)
39
INSTALLATION
Outboard Motor Installation
Installation Height
When the outboard motor is
installed extremely low, the idle
port may be immersed and the
engine may become hard to start
or may run poorly. Check that
the idle port is high enough from
the water level when the engine
is stopped with the boat fully
loaded.
The water level must be at least
100 mm (4 in) above the
anticavitation plate, otherwise
the water pump may not receive
sufficient cooling water, and the
engine will overheat.
Standard torque:
WASHER (4)
WASHER (8)
BOLT (12
119 mm)
TRANSOM HEIGHT
BOAT TRANSOM
HEIGHT
NUT
STERN
BRACKET
IDLE
PORT
0
50 mm
(0
2 in)
The standard torque is given just as a
guideline. Torque of the nut can be
different according to the material of
the boat. Consult with an authorized
Honda outboard motor dealer.
Set the outboard motor on the boat
and secure with the bolts, washers,
and lock nuts.
Apply the silicone sealant (Three
Bond 1216 or equivalent) to the
outboard motor mounting holes.
The correct dimensions differ
according to the type of the boats
and the configuration of the
bottom of the boats. Follow the
manufacture’s recommended
installation height.
The anticavitation plate of the
outboard motor should be
0
50 mm (0
2 in) below the
bottom of the boat.
1.
2.
05/10/26 09:50:14 3CZW0612_039