The propeller is thin and
sharp. To protect your hands,
wear the heavy gloves during
replacement.
When replacing, remove the
emergency stop switch clip
to prevent an accidental
startup of the engine.
125
Propeller
Replacement
MAINTENANCE
THRUST WASHER
PROPELLER
PLAIN
WASHER
COTTER PIN
CASTLE NUT
Tightening Torque:
1.0 N·m (0.1 kgf·m, 0.7 lbf·ft)
Upper Limit of Torque:
44 N·m (4.5 kgf·m, 33 lbf·ft)
Tighten the castle nut with your
hand first until the propeller has no
play. Then, tighten the castle nut
again with a tool until the groove
in the castle nut aligns with the
cotter pin hole. (Note that this tool
is not included in the tools that
come together with the outboard
motor.)
Install the new propeller in the
reverse sequence to removal.
Remove the cotter pin then remove
the 18 mm castle nut, 19 mm plain
washer, propeller and thrust
washer.
If the propeller is damaged by
striking a rock, or other obstacle,
replace the propeller as follows.
Be sure to replace the cotter pin
with a new one.
Install the thrust washer with the
grooved side toward the gear case.
Use a genuine Honda cotter pin
and bend the pin ends as shown.
1.
2.
3.
4.
05/10/26 10:04:20 3CZW0612_125
