Honda HS1336i, Owner'S Manual

Page: 53 / 144

51
OPERATION
Use the LOW position (i.e. position for clearing hardened snow) only for clearing
hardened snow. Do not set the auger housing in this position while clearing soft
snow or clearing on a bumpy road. This can damage the road surface or cause
stones to be thrown out of the auger, which is very dangerous. Also, it can cause
excessive wear and damage to the snow clearing part of the snow blower. Damage
from stones or gravel is not covered under the Distributor's Limited Warranty.
• When the mode selector switch is in AUTO or POWER, the auger housing
automatically rises while going in reverse.
USA model only:
In case the auger clutch switch is in the ON position, the auger is
automatically returned to the original position when the snow blower is
transporting forward again.
• If you want to stop the automatic movement of the auger housing, change
the mode selector switch to the MANUAL position.
• To stop the automatic movement of the auger housing, push the control
switch once to the opposite direction of the movement.
• Frequent operation of the auger housing control switch activates the
protection function and makes the drive control warning indicator (orange)
blink, which prevents you from adjusting the snow clearing part of the snow
blower. Stop operating the auger housing control switch and wait a few
seconds before operating the switch again.
31V156250.book 51 ページ ２０２０年１２月２２日 火曜日 午後１時３６分